Changzhou Bedefu three-jaw chuck is cost-effective

Changzhou Beidefu Pneumatic Tools Co., Ltd. specializes in the design and production of power chucks and rotary oil (gas) cylinders. The company has an experienced design team and a production team with strong manufacturing capabilities. It can provide users with high-quality services, and can also design and produce various special fixtures according to different user needs, and install hydraulic chuck systems on various machine tools. The company has rich manufacturing experience especially in vertical lathe hydraulic chucks, front-mounted pneumatic pipe thread chucks, double-action chucks and rotary cylinders. The company will, as always, adhere to the business philosophy of 'technological innovation, manufacturing high-quality products', fully implement quality management, strictly control product quality, continuously improve the service system and product series, and continue to strive to remain a more professional and influential clamp manufacturer and service provider in the country. The company has always pursued the business policy of 'customer first', adhered to the management philosophy of 'quality first', and served customers wholeheartedly. The company looks forward to continuing to receive support and cooperation from our customers. Thank you very much for your trust and support in our company.

If the three-jaw pneumatic chuck is used incorrectly or with inappropriate lubrication, it is more likely to cause problems. For example, it will not work properly at low pressure, so the power chuck must be lubricated correctly. In addition, the workpiece is heavy, so it is better to use four-claw processing. Just move each of the four claws outward a little. In this way, the distance between the legs is larger than the outer circle of the workpiece. Then place the round workpiece between the four claw feet. At the same time, place 2 nuts on two of the four claws. You can place this nut anywhere, horizontally or vertically. The principle of placing the nut is that the diameter of the round workpiece plus the thickness of the nut is greater than the original distance between the two claws.

Under the influence of the hydraulic oil, it presses the oil cylinder to hold the workpiece, and the two indexing oil cylinders move in reverse direction, pushing the indexing plate to rotate counterclockwise to complete the indexing of the workpiece. Special fixture: a fixture that can be used for different workpieces. Combination fixture: The operating principle and characteristic definition of the combination fixture: It is a new type of process equipment developed on the basis of the standardization of machine tool fixture components. It is assembled from a set of specialized components and components whose structure and size have been standardized, serialized and standardized. It can be seen that the combination fixture is only a practical fixture that can be reused many times. The production practice has shown that it is equivalent to a special fixture for one-time use. It covers R&D and production with assembly, so it has the following characteristics: flexibility, wide application range, and can greatly shorten the production preparation distance. It can save a lot of manpower and material resources and reduce the consumption of metal materials. It can greatly reduce the warehouse area for storing public fixtures and simplify management operations. Disadvantages: Larger appearance and bulky.

Because the workpiece is heavy, use the tailstock to support the workpiece. In this way, small round workpieces can be adjusted on the four claws. Be careful to adjust your feet slowly to prevent the nuts from falling out. After adjustment, tighten the four claws. Precautions When adjusting, pay attention to the nut of the pad to prevent it from falling. Every 6 months, remove the chuck, disassemble it, clean it (keep the sliding surface of the clamp jaw clean), and lubricate it. If you are cutting cast iron, clean it thoroughly at least once or multiple times every 2 months and check all parts for cracks and wear (replace the severely worn parts immediately). After the inspection is completed, the oil must be fully supplied before assembly.